Rough Openings For Doors

                                                                                         

One of the most important parts of framing walls is getting
the rough openings right. Items that determine what the
heighth of your opening will be are floor finishes and the
use of underlayment. Door widths will stay constant with the
size of a standard door.

In new construction most doors are hung after the floors are
installed. This allows flooring contractors (tile, hardwood,
vinyl, laminate) to lay their flooring products without
making tricky cuts around door jambs. It also makes for a
neat and clean door installation. Exceptions to this are
carpeted floors. Doors are hung before the carpeting is
laid. When doors are hung in carpeted areas, its a good idea
to shim them up 1/2", putting a shim under each jamb leg.
This eliminates the need to cut the doors down after the
carpet is installed.

For a 6' 8" high door (80 inches) I like to frame my rough
opening heighth at 82 3/4". This allows room for all the
situations mentioned above. If your header material is a
double 2x12, holding it to the top plate will give you that
heighth.

Rough openings for door widths are pretty much standard. The
rough opening width is 2 inches wider than the door itself.
this allows room for the door jambs which are usually 3/4"
thick. This gives you approximately 1/2" of play and shim
room when installing a prehung door. For a 36" door (3' 0")
the rough openig width would be 38". Here are the most
common door sizes and their rough openings.

Door Size Rough Opening Size

2' 0" x 6'8" -26" x 82 3/4"
2' 2" x 6'8" -28" x 82 3/4"
2' 4" x 6'8" -30" x 82 3/4"
2' 6" x 6'8" -32" x 82 3/4"
2' 8" x 6'8" -34" x 82 3/4"
2' 10"x 6'8" -36" x 82 3/4"
3' 0" x 6'8" -38" x 82 3/4"

To figure the rough opening for double doors or french
doors, take the door size times 2 and add 2". The most
common sizes for exterior doors are the 2'8" and the 3'0"
doors. The 2'8" is usually used for the back door and the
access door from the garage. That size door for exterior use
is being used less these days because of the size of
appliances and furniture. Exterior doors with sidelights and
sliding patio doors rough openings vary from manufacturer to
manufacturer. These should be verified and gotten from the
supplier.

Getting the rough openings right the first time keeps the
sawzall in its carrying case and having to change the
opening after the walls are drywalled and painted.

To learn more about installing doors, check the archives of
this blog or go to www.sawkerfs.com

Mike Merisko (c) 2006
www.sawkerfs.com

About the author:
Mike Merisko has been a carpenter for 26 years. Most of those years were spent in the homebuilding and remodeling industries. He was also in business as a carpentry and general contractor. While that is his forte, he also has experience in bridge building, commercial construction, and exhibit building which is how he earns his living these days. You can browse through articles by him and others at his website http://www.sawkerfs.com or visit his blog at http://www.sawkerfs.blogspot.com

Article Source: http://www.Free-Articles-Zone.com