Jacuzzi Hot Tub delivery

                                                                                         

Hot Tub delivery and installation will be straight forward with some advanced planning and preparation.

Some simple ideas that you need to cover are simply where the Spa is actually going to be located.

Usually they go outside as they are able to be used in more or less any outdoor environment.

However some people like them inside, perhaps as part of a gym or a sports complex.

One very important consideration is the access to the proposed location of the Spa.

The dimensions of the door and gate openings to your property need to be carefully measured and compared with the actual size of the spa. Remember also that the Spa will usually be delivered on something like a piano trolley or a specialized spa dolly so some extra height needs to be allowed for getting in under gates with arches. Bear in mind that arches and that kind of thing can provide some height restriction that may then involve the use of a crane.

You need to consider the weight of the spa when full with water and people.

Will the proposed location be it a roof terrace, deck, patio floor or the floor of an inside location be able to support the load bearing weight?

Do you have sufficient electricity supply which should be from a dedicated independent breaker in your fuse box? Is that supply within a convenient distance from the proposed location.

Is there a sufficient drain close by that will take the water when you empty the spa?

Do not place the spa on bare ground. The ground must be prepared in some way either by simple paving stones laid on a hard core base or on to a properly prepared concrete base.

Do not place your spa below overhead power, telephone or cable lines.

Make sure that you can access the spa from all four sides and leave at least 30 inches so as to give sufficient space for servicing or routine maintenance. Sometimes we are asked to service spas when they are very close to a wall and whilst you can get access to actually work on the spa it is more or less impossible.


As always, it is very good advice that. one should only buy a product that comes from an American or Western, internationally recognized, manufacturer of Hot Tubs. One that has been established for many decades.

Then there is every chance that the product will last and last and provide very many years of faultless service.

The reasoning is very simple the internationally recognized manufacturer will back his products with a real guarantee, so if there is a fault it does fall back on the manufacturer and not on the consumer.

The reason why they can provide these guarantees is that they have had many decades of experience and therefore they build their products with the proper quality parts and components so ensuring that is will not fail in the first place.

It is for that simple reason and that reason alone that they are then prepared to provide a meaningful long life guarantee.

This article is not meant to be exhaustive but to provide some basic ideas and points to consider. It is one in a series of articles on this topic.

About the author:
The Author Jacuzzi John markets luxury American Hot Tubs in Portugal, Spain and through out Europe for further information please go to his web site at Portugal Hot Tubs

Article Source: http://www.Free-Articles-Zone.com